Steps I did to switch my Sound Equipment:
1) Bought Ess-Twin Sound Equipment:
2) Bought Acrylic Conformal Coating:
3) Acquired a Good Set of Hex Drivers:
4) Understood that I used to be about to wreck the guarantee & presumably, the product.
5) Eliminated the Eight Finish-screws from the sound unit
6) Eliminated Four Philips screws from the micro board
7) Took care to not contact the board – solely the perimeters
8) Laid out a fabric, and reduce one for overlaying the uncovered wires
9) Sprayed 2 mild coats of conformal coating on both sides. 5 minute wait in between every coating.
10) Reassembled the sound unit and put in.

Radio I used on this video is a Flysky Noble NB4:

Gens ace 11.1V 2200mAh 3S 45C LiPo Battery Pack with Deans Plug : $28!

I wish to say that modifying ANY digital half is at all times a danger. Introducing chemical substances and water to {an electrical} board is rarely really helpful – but when persons are going to aim it – I determine providing my experiences for evaluate may be entertaining to some. Bear in mind – try this modification at your OWN RISK!

SUBSCRiBE & “Ring the Bell" ►

"1 Million Views Membership":

RCSPARKS Shirts & MERCH:

RC ADVENTURES™/ RCSparks Studio™ © 2019 Medic Media Productions Inc. All rights reserved. Publication, replica or distribution of this movie by any means by any means – together with with out limitation digital transmission through web or e-mail, or re-uploading current movies & re-uploading such materials on any web site wherever on the earth — is strictly prohibited with out the prior written consent of Medic Media Productions Inc.

https://www.youtube.com/watch?v=gNw9HRazo1c